How to set up Smart Construction Rover as base station using External Radio as correction data in RTF500

Issue

How to set up Smart Construction Rover as base station using External Radio as correction data in RTF500.

Answer

Please follow Explanation step by step procedure to set up Smart Construction Rover as base station using External Radio.

Explanation

Connect Port1 cable to Modem through RS232C connector as below diagram :

Receiver Mode set to Base Station

1) Port1 Baudrate Modem (depends on the radio and range ,  FYI: 38,400 is basic for Japan market)

2) Satellites setting ON/OFF . ( depends on site condition)

3) Input coordinate ( make sure the unit is correctly set either to dms or deg)

4) Input antenna height and base phase center

5) Save and reboot

To check Smart Construction Rover Receiver lamp behavior as below picture